PICKING STATION Static - LJH Static (RPM1809)
RPM1809 PICKING STATION Static - LJH Static
Ex Works Swansea
New Floor required
New Hydraulic Drive or
Electric Motor required
Of heavy- duty fully welded lattice gantry construction to minimise the amount of support legs required in the skip area.
Heavy- duty receiving hopper from 8mm thick mild steel plate at tail end of conveyor section for reject belt to discharge into. Heavy- duty impact bars under belt at feed point. Inclined feed conveyor with side skirts up onto horizontal section for manual selection.
Conveyor belting P.V.G. 220 B 1200 mm wide p.v.c. coated cover with low friction backing vulcanised joint, belt being supported by low friction polyurethane skid strips
Conveyor drums are of heavy- duty design and constructed with welded EN8 shafts. Head drum lagged with diamond pattern material to prevent belt slippage.
Two picking stations on both sides of belt consisting of a 1200 x 400 picking chute with adjacent mounted emergency stop button. The picking section will be guarded along its full length.
Operator’s platforms down both sides of unit approximately 850mm wide.
GRP Cabin over picking section 3.6 metres wide, 2.4 m high.
4off entry/exit doors with glass openings, 8off 1000 x 1000 windows and 3off fluorescent lights.
Access to picking section up from ground level, by stairs, mounted at rear end of machine on both sides.
Clearance on underside picking station 3 metres.
Did you know that we have finance options for this item? Click here to find out more.
CALL TO BUY
Ready to buy or want more information?